Siemens SC9000 Cleaning, Parts List GCX P/N, Description, Siemens P/N Dräger P/N

Cleaning

1.The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital environment (e.g. diluted bleach, ammonia, or alcohol solutions).

2.The surface finish will be permanently damaged by strong chemicals and solvents such as acetone and trichloroethylene.

3.Steel wool or other abrasive material should never be used.

4.Damage caused by the use of unapproved substances or processes will not be warranted. To verify compatibility, It is recommended that any cleaning solution be tested on a small area of the arm that is not visible.

5.Never submerge the mounting arm. Wipe any cleaning agents off of the arm immediately, using a water-dampened cloth. Dry the arm thoroughly after cleaning.

CAUTION: GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize mounted devices or accessory equipment, refer to the specific instructions supplied with those products.

PARTS LIST

GCX P/N	Dräger P/N	DESCRIPTION
WMM-0002-02	MM15278	12” M Series Pivot Arm
DR-0017-82	MM15719	4” Cato Channel (2)
	M29110	Accessory Track Brass Plate (Dräger)

Power Supply Right Side (CPS)

	GCX P/N	Siemens P/N		Dräger P/N	DESCRIPTION
--		4720129	--		Siemens Power Supply Holster
	SI-0041-06	--		MM15754	Siemens Power Supply Flush Mount for
					Siemens P/N 4720129
	DR-0017-82	--		MM15719	4" Channel /w T-Nuts
--		--		M29110	Accessory Track Brass Plate (Dräger)

DU-DR-0016-SC9000 Rev A 6/4/02 GCX Corp. Page 4 of 4