Description, Charging, Shaving, Cleaning

English

Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun Shaver.

Warning

Your shaver is provided with a special cord set with integrated Safety Extra Low Voltage power supply. Do not exchange or manipulate any part of it. Otherwise there is risk of electric shock.

Description

1Shaver foil

2Cutter block

3Release button

4On/off switch («start/stop»)

5Long hair trimmer

6Charging light (green)

7Special cord set

Charging

The best environmental temperature for charging is between 15 °C and 35 °C.

•Connect the shaver to an electrical outlet with the motor switched off and charge it for at least 8 hours.

•The green charging light (6) shows that the shaver is being charged.

•Once the shaver is completely charged, discharge the shaver through normal use. Then recharge to full capacity.

•A full charge provides up to 30 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/discharging cycles.

•If the rechargeable batteries are discharged, you may also shave by connecting the shaver to an electrical outlet via the special cord set.

Shaving

Press the on/off switch (4) to turn the shaver on.

Trimmer:

When the long hair trimmer (5) is activated, it allows the controlled trimming of moustache or sideburns.

Tips for the perfect shave

•We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.

•Hold the shaver at right angles (90°) to the skin. Stretch the skin and shave against the direction of beard growth.

•To maintain 100% shaving performance, replace the shaver foil and cutter block at least every 18 months or when worn.

Cleaning

This appliance is suitable for cleaning under an open water tap.

Warning: Detach the hand-held part from the power supply before cleaning it in water.

Regular cleaning ensures better shaving performance. Rinsing the shaving head after each shave under running water is an easy and fast way to keep it clean:

•Switch the shaver on (cordless) and rinse the shaving head under hot running water. A natural based soap may also be used provided it contains no particles or abrasive substances. Rinse off all foam and let the shaver run for a few more seconds.

•Next, switch off the shaver and press the release buttons. Remove the shaver foil and the cutter block. Then leave the disassembled shaving parts to dry.

Alternatively, you may clean the shaver using the brush provided:

•Switch off the shaver. Remove the shaver foil.