Braun 4615, 4605 manual Description

Page 4

English

Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun shaver.

Technical specifications

Wattage via cord set: 4 W, automatic power supply 220-240 V~ / 50-60 Hz

on, the light comes on again, this indicates that the shaver is being recharged to maintain its full capa- city.

Model 4615 only: The red low charge light will come on when the battery capacity has dropped below 20%, provided the shaver is switched on. The remaining capacity will then be sufficient for 1 to 2 shaves.

Description

1Foil protection cap

2Shaver foil

3Cutter block

4Foil frame

5Release buttons

6Long hair trimmer

7Central switch

8Low charge light (4615 only)

9Charging light

10Shaver socket

11Mains adapter

Charging the shaver

Via the adapter, connect the shaver to the mains with the motor switched off. Charge for at least 8 hours (trans- former and shaver might get warm). Once the shaver is completely charged, shave until fully discharged. Then recharge to full capacity again.

A full charge will give up to 25 minutes of cordless shaving time depending on your beard growth. However, the maximum battery capacity will only be reached after several charging/dis-charging cycles.

Best environmental temperature range for charging is 15°C to 35°C.

Indicator lights

The green charging light shows that the shaver is being charged.When the rechargeable battery is fully charged, the charging light goes off. If later

Shaving

Turn on the shaver («on»)

Trimmer («trim»): When the long hair trimmer is activated, it allows the controlled trimming of moustache or sideburns.

Tips for the perfect shave

We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.

Hold the shaver at right angles (90°) to the skin. Stretch your skin and shave against the direction of beard growth.

To ensure optimum shaving per- formance, we recommend to re- place the shaver foil and cutter block every 18 months, or when the parts are worn.

Keeping your shaver in top shape

Cleaning under running water

After each shave, turn on the shaver and clean it under running hot water. Occasionally use soap (natural based liquid soap without particles and abrasive substances). Then rinse off all foam and let the shaver run for another moment.

Brush cleaning

Instead of cleaning under running water, you may clean your shaver with a dry

Image 4
Contents TwinControl Off Trim Description Environmental notice Page Page Page Page Page Battery removal at the end of the product’s useful life 100-207/00/V-02 GB/China/Korea