NOTE: | If the cables have become dis- | Traction Drive Cable | Auger Drive Cable |
connected, connect cables as shown in |
|
| |
Figure | 7. |
|
|
Figure 7
HOW TO ASSEMBLE THE CHUTE
1.Remove the carriage bolt. See Figure 8.
2.Raise the chute deflector into op- erating position.
3.Fasten chute deflector to flange with carriage bolt, Make sure to installwith head of carriage bolt on the inside of the flange.
4.Fasten with washer and Iocknut.
5.13ghten Iocknut securely. NOTE: Make sure all carriage
bolts in flange are tight. DO NOT
OVERTIGHTEN,
DEFLECTOR
Chute Deflector
NutOperating_
Position
Carriage Bolt
Flange
Figure 8
HOW TO SET THE SKID HEIGHT
Your snow thrower is equipped with | height for different conditions, see To | ||
height adjust skids on the outside of the | Adjust | Skid | Height paragraph in the |
auger housing. To adjust the skid | Service | And | Adjustment section. |
HOW TO SET THE LENGTH OF THE CABLES
The cables were adjusted at the factory and no adjustments should be neces- sary. However, after the handles are put in the operating position, the cables can
be too tight or too loose. If an adjust- ment is necessary, see =How To Check
And Adjust The Cables" in the Service And Adjustment section.
