Craftsman 536881851 manual Tools Required for Assembly, To Remove Snow Thrower from Carton

A safetyARNING:glassesAlwaysoreyewearshields

while assembling snow thrower.

TOOLS REQUIRED FOR

ASSEMBLY

1 - Knife to cut carton

2 - 1/2 inch wrenches

(or adjustable wrenches) 2 - 9/16 inch wrenches

(or adjustable wrenches) 2 - 3/4 inch wrenches

(or adjustable wrenches)

1 - Pliers (to spread cotter pin)

1 - Screwdriver

1 - Measuring tape or ruler

Figure 1

Figure 1 shows the snow thrower in the shipping position.

Figure 2 shows the snow thrower com- pletely assembled.

References to the right or left hand side of the snow thrower are from the view-

point of the operator's position behind the unit.

TO REMOVE SNOW THROWER FROM CARTON

,Locate all parts packed separately and remove from the carton.

NOTE: Place fuel stabilizer in a safe place untilneeded for storage.

,Remove and discardthe packing materialfrom around the snow thrower.

3.Cut down all four comers of the car- ton and lay the panels flat.

4.Cut the straps that secure the axle to the pallet.

5.For shipping purposes, the height adjust skids are attached to the pallet. Remove the screw that se- cures each height adjust skid to the pallet. See Figure 2.

6.Roll snow thrower off the pallet by pulling on the lower handle. CAU- TION: DO NOT back over control cables.

7, Remove all packing material from the unit.

8.Cut ties securing the clutch control cable to the lower handle and lay

cable back away from the motor

frame.

Auger Drive Lever	n
"_	_ L_-------.- Traction
_	Drwe Lever
	_" Clutch Cable
	nk Assembly
ShifteJ '__r_	[_ft_tector
Lever

Height

Adjust

Skid

Scre_Figure2

7