Braun 6520, 6515, 6510 manual Pilot lights, Shaving, Keeping your shaver in top shape

3Pilot lights

•The green charging light indicates that the shaver is connected to the mains.

Model 6520/6515:

After the cell unit is fully charged, the charging lights starts to flash.

Model 6510:

After the cell unit is fully charged, the green charging light goes off. If later on, the charging light comes on again, this indicates that the shaver is being recharged to maintain its full capacity.

Model 6520/6515 only:

The red low-charge light flashes when the capacity has dropped below 20 %, provided the shaver is switches on. The remaining capacity will then be sufficient for 2 to 3 shaves.

4Shaving

4.1Switch lock

The shaver is delivered with switch lock activated

(position «• lock»). Push the switch lock to position «•» before you shave for the first time.

To avoid accidentally switching the shaver on, e. g. when travelling, push the switch lock to position «• lock».

4.2Switch positions

0 = Off

1 = Shaving with the pivoting head.

The pivoting cutting system automatically adjusts to every contour of your face.

2 = Shaving with the pivoting head locked ad an angle (to permit shaving in difficult areas, e. g. under the nose).

3 = The long hair trimmer is activated

(for trimming sideburns, moustache and beard).

4.3Shaving with the cord

If the cell unit is discharged, you may also shave

with the shaver connected to the mains

(100 - 240 V Q). (If the shaver should not run immediately, charge it with the switch on position «0» for approx. 1 minute.)

Tips for the perfect shave

•We recommend to shave before washing, as the skin tends to be slightly swollen after washing.

•Hold the shaver at right angles (90°) to the skin.

•Stretch your skin and shave against the direction of beard growth.

5Keeping your shaver in top shape

5.1 Cleaning

•After shaving, switch the shaver off. Press the release button, take off the triple shaving frame and gently tap it out on a flat surface.

•Then thoroughly clean the duo cutter block with the brush as well as the inner area of the pivoting head.

•About evere four weeks, clean the duo cutter block with Braun cleaning agents.

5.2Changing the shaving parts

To maintain optimum shaving performance, you should replace the triple shaving frame or the duo cutter block, when these parts are worn.

4 5