English
Our products are designed to meet the highest standards of quality, functionality and design. We hope you enjoy your new Braun Shaver.
Warning
Your shaving system is provided with a special cord set, which has an integrated Safety Extra Low Voltage power supply. Do not exchange or tamper with any part of it, otherwise there is risk of an electric shock.
To prevent the cleaning fluid from leaking, ensure that the Clean&Renew station is placed on a flat surface. When a cleaning cartridge is installed, do not tip, move suddenly or transport the station in any way as cleaning fluid might spill out of the cartridge. Do not place the station inside a mirror cabinet, nor place it on a polished or lacquered surface.
The cleaning cartridge contains a highly flammable liquid so keep it away from sources of ignition. Do not expose to direct sunlight and cigarette smoking nor store it over a radiator.
Keep it out of reach of children.
Do not refill the cartridge and use only original Braun refill cartridges.
Description
Clean&Renew™ station
1Level indicator
2Lift button for cartridge exchange
3
4Start button
5Station power socket
6Cleaning cartridge
Shaver
7Shaver foil
8Cutter block
9Foil release buttons
10Long hair trimmer
11Comfort setting switch «sensitive»
12
13On/off switch
14Shaver display
15Cleaning light (yellow)
16Replacement light for shaving parts
17Reset button
18Shaver power socket
19Special cord set
20Etui
A Before shaving
Prior to first use, you have to connect the
shaver to an electrical outlet using the special cord set (19) or alternatively, proceed as follows:
Installing the Clean&Renew station
•Using the special cord set (19), connect the station power socket (5) to an electrical outlet.
•Press the lift button (2) to open the housing
•Hold the cleaning cartridge (6) down on a flat, stable surface (e.g. table).
•Carefully remove the lid from the cartridge.
•Slide the cartridge into the base of the station as far as it will go.
•Slowly close the housing by pushing it down until it locks.
Charging the shaver in the Clean&Renew station
Insert the shaver head down into the cleaning station. (The contacts (12) on the back of the shaver will align with the contacts (3) in the cleaning station).
If required, the Clean&Renew station will start charging the shaver now.
A full charge provides up to 45 minutes of cordless shaving time. This may vary according to your beard growth.
The best environmental temperature for charging is between 5 °C to 35 °C. Do not expose the shaver to temperatures higher than 50 °C for extended periods of time.
9