Wells F-49RT INSTALLATION continued, WARNING Electric Shock hazard, Risk of Damage

INSTALLATION (continued)

WARNING: Electric Shock hazard

All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician.

DO NOT open any access panel which requires the use of tools. Failure to follow this warning can result in severe electrical shock.

F-49RT RETHERMALIZER ELECTRICAL INSTALLATION

This unit is equipped with a cord and NEMA 6-30P plug, and requires a

properly installed NEMA 6-30R receptacle. Contact a licensed	elec-
trician to install an appropriate 208 VAC or 240 VAC 30 amp	electric
circuit and grounded receptacle.

Be sure the TEMPERATURE CONTROL KNOB is turned to the OFF position, then plug the POWER CORD into a matching receptacle.

Fig. 3 F-49RT Power Plug and Receptacle Configuration

CAUTION:

Risk of

Damage

DO NOT connect or energize this appliance until all installation instructions are read and followed. Damage to the appliance will result if these instructions are not followed.

CAUTION:

Electrical Shock

Hazard

The ground pin of the power cord plug is part of a system designed to protect you from electric shock in the event of equipment damage.

DO NOT cut the ground pin from the power cord plug in order to fit an existing receptacle;

DO NOT twist a blade of the power cord plug in order to fit an existing receptacle.

Contact a licensed electrician to install an appropriate electrical circuit and receptacle.

IMPORTANT: Damage due to being connected to the wrong voltage or phase is NOT covered by warranty.

5