HP 5120 SI, 5120 48G Introduction to wall anchor kit, Installation procedure, Model Hole distance

Table 9 Models supporting wall mounting

Model	Hole distance
5120-8P SI	98.5 mm (3.88 in)
5120-8G-PoE+ SI	174.0 mm (6.85 in)
5120-8G-PPoE+ SI	174.0 mm (6.85 in)

Introduction to wall anchor kit

NOTE:

No wall anchor kit is provided with the 5120 SI Switch Series.

A wall anchor kit comprises an anchor and a screw, as shown in Figure 51. The screw must have an outer diameter of no less than 4 mm (0.16 in) for wall mounting.

Figure 51 Wall anchor kit

Installation procedure

To mount the switch to a wall:

1.Drill two holes at the same height and X mm apart at the locations you marked. See Figure 52. Figure 52 Hole distance

Xmm

NOTE:

•The distance X between holes varies with devices. For specific distances, see Table 9.

•Drill holes according to the sizes of the anchors and screws so that the anchors can go into the holes with only the edges remaining outside, and the screws can be tightly fixed on the wall.

31