HP 5120 SI, 5120 48G, 5120 EI manual Verifying the installation, Removing a dedicated CX4/SFP+ cable

To connect a CX4 or SFP+ cable to a port on a CX4/SFP+ interface card:

1.Wear an ESD-preventive wrist strap and make sure it makes good skin contact is well grounded.

2.Correctly orient one connector of the cable with the port and insert the cable connector into the port.

Removing a dedicated CX4/SFP+ cable

To remove a CX4 or SFP+ cable from a port on a CX4/SFP+ interface card:

1.Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded.

2.Hold the cable connector and pull the pull latch of the connector to remove the cable from the switch.

Verifying the installation

After you complete the installation, verify that:

•There is enough space for heat dissipation around the switch, and the rack or workbench is stable.

•The grounding cable is securely connected.

•The correct power source is used.

•The power cords are properly connected.

•All the interface cables are cabled indoors. If any cable is routed outdoors, verify that the socket strip with lightning protection and lightning arresters for network ports have been properly connected.

43