release |
| washable |
release | release |
washable | washable |
new |
| old |
| ||
|
Alternatively, you may clean the shaver using the brush provided:
•Switch off the shaver. Remove the foil and cutter cassette 8 and tap it out on a flat surface. Using the brush, clean the inner area of the pivoting head. However, do not clean the cassette with the brush as this may damage it.
Cleaning the housing
From time to time clean the housing of the shaver and the Clean&Renew station with a damp cloth, especially inside the cleaning chamber where the shaver rests.
Replacing the cleaning cartridge
After having pressed the lift button 2 to open the housing, wait for a few seconds before removing the used cartridge to avoid any dripping.
Before discarding the used cartridge, make sure to close the openings using the lid of the new cartridge, since the used cartridge will contain contaminated cleaning solution.
| 9000 | 9000 | |
release | S e r i e s | ||
S e r i e s | |||
| washable |
|
mer | 360°Complete |
|
9000 | 9000 | |
S e r i e s | ||
S e r i e s | ||
| ||
360°Complete |
|
Keeping your shaver in top shape
Replacing the foil and cutter cassette / reset To maintain 100% shaving performance, replace the foil and cutter cassette 8, when the replacement symbol lights up on the shaver display r (after about 18 months) or when cassette is worn.
The replacement symbol will remind you during the next 7 shaves to replace the foil and cutter cassette. Then the shaver will automatically reset the display.
After you have replaced the foil and cutter
cassette, use a
efor at least 3 seconds to reset the counter. While doing so, the replacement light blinks and goes off when the reset is complete. The manual reset can be done at any time.
Accessories
Available at your dealer or Braun Service Centres:
•Foil & cutter cassette No. 9000
•Cleaning cartridge Clean&Renew CCR
28