Braun BS 8995 manual Description

Page 24

eco normal intensive

cartridge

full

 

empty

1

2

Description

1Special cord set

2«start cleaning» button

3Station-to-shaver connecting contacts

4Station lift button for cartridge exchange

5Display for cleaning programs

6Display for cleaning fluid status

7Station mains socket

8Cleaning cartridge

9Shaver foil protection cap

10Shaver foil

11Cutter block

12Foil release buttons

13Long hair trimmer

14Shaver-to-station connecting contacts (shaver backside)

15Switch

16Shaver display

17Info key

18Pilot light

19Shaver mains socket

Before shaving

If you wish, you may start shaving right away (if the shaver is charged, see section «Shaver display»). However, we recommend to follow the procedure described here:

Using the special cord set (1), connect the mains socket of the Clean&Renew™ station (7) to an electrical outlet.

Press the station lift button (4) to open the housing.

Hold the cleaning cartridge (8) down on a flat, stable surface (e.g. table).

Carefully remove the lid from the cartridge.

Slide the cartridge into the base of the station as far as it will go.

Slowly close the housing by pushing it down until it locks.

24

Image 24
Contents Fix on off Trim 8995 Page Stop Page Page Page Page Start Full Empty Clean eco normal intensive Page Page On fix New Old Page Page Page Off on fix Page Page Page Page English Description We recommend cleaning after each shave Shaving Shaver display Page Accessories Page 646-448/00/IX-07