Braun 8581 manual Description

Page 25

Description

1.Low-voltage adapter

2.«start cleaning» button

3.Station-to-shaver connecting contacts

4.Station lift button for cartridge exchange

5.Display for cleaning programs

6.Display for cleaning fluid status

7.Station mains socket

8.Cleaning cartridge

9.Shaver foil protection cap

10.Shaver foil

11.Cutter block

12.Foil release buttons

13.Long hair trimmer

14.Shaver-to-station connecting contacts (shaver backside)

15.Switch

16.Shaver charging lights (green)

17.Shaver low-charge light (red)

18.Pilot light

19.Shaver mains socket

Before shaving

If you wish, you may start shaving right away (if the shaver is charged, see section «Shaver indicator lights»). However, we recommend to follow the procedure described here:

Using the low-voltage adapter (1), connect the mains socket of the Clean&Charge station (7) to the mains.

Press the station lift button (4) to open the housing.

Hold the cleaning cartridge (8) down on a flat, stable surface (e.g. table).

Carefully remove the lid from the cartridge.

Slide the cartridge into the base of the station as far as it will go.

Slowly close the housing by pushing it down until it locks.

eco normal intensive

cartridge

full

 

empty

1

2

25

Image 25
Contents 8590 8585 8581 Page Stop Page Page Page Page Activator 8590/8585/8581 Full Empty Clean Eco Normal Intensive Page Page 8590 Old new 20 40 60 80 Page Page Page Page Page Page Page Activator 8590/8585/8581 English Description Intensive We recommend cleaning after each shaveAutomatic cleaning Switch positionsTips for the perfect shave Shaving with the cordThorough manual cleaning Quick cleaningCleaning the housing Replacing the cartridgeShaver foil and cutter block No Cleaning cartridge Clean&Charge CCRSubject to change without notice GuaranteePage 644-457/02/XII-03