Shaving
If the shaver is locked into the Clean&Charge station, push the «start cleaning» button (2) to release the shaver and take it out.
Switch positions
off = (switch is locked)
Press and push up the switch to operate the shaver: 1 = Shaving with the pivoting head
(the pivoting cutting system automatically adjusts to every contour of your face).
2= Shaving with the pivoting head locked at an angle (to permit shaving in difficult areas, e.g. under the nose).
3= The long hair trimmer is activated
(for trimming sideburns, moustache and beard).
Tips for the perfect shave
We recommend that you shave before washing, as the skin tends to be slightly swollen after washing.
Hold the shaver at right angles (90°) to the skin.
Stretch your skin and shave against the direction of beard growth.
To maintain 100% shaving performance, replace your foil and cutter block every 18 months or when worn.
Shaving with the cord
If the shaver is completely discharged and you do not have the time to recharge in the Clean&Charge station, you may also shave with the shaver connected to the mains via the
After shaving
Automatic cleaning
After each shave, return the shaver to the Clean&Charge station and proceed as described above in the section «Before shaving». All charging and cleaning needs are then taken care of. With daily use, a cleaning cartridge should be sufficient for about 30 cleaning cycles.
The hygienic cleaning solution cartridge contains alcohol which, once opened, will naturally evaporate slowly into the surrounding air. Each cartridge, if not used daily, should be replaced after approximately 8 weeks.
1 2
1 2
1 2
3
8590 |
sta
27