Before shaving, Installing the Clean&Renew station

0Shaver head «lock» switch q Pop-out long hair trimmer w On/off switch

e (–) setting button (sensitive) r (+) setting button (intensive) t Reset button

z Shaver display

u Shaver-to-station contacts i Shaver power socket

o Travel case

p Special cord set

Before shaving

Prior to ﬁrst use you must connect the shaver to an electrical outlet using the special cord set p or alternatively proceed as below.

Installing the Clean&Renew station

•Using the special cord set p, connect the station power socket 6 to an electrical outlet.

•Press the lift button 2 to open the housing.

•Hold the cleaning cartridge 7 down on a ﬂat, stable surface (e.g. table).

•Carefully remove the lid from the cartridge.

•Slide the cartridge into the base of the station as far as it will go.

•Slowly close the housing by pushing it down until it locks.

The cleaning ﬂuid display 1 will show how much ﬂuid is in the cartridge:

up to 30 cleaning cycles available

up to 7 cleaning cycles remaining

new cartridge required

Charging and cleaning the shaver

Insert the shaver head down into the cleaning station. (The contacts u on the back of the shaver will align with the contacts 3 in the cleaning station).

If required, the Clean&Renew station will auto- matically charge the shaver. The hygiene status of the shaver will also be analyzed and one of the following cleaning program indicators 5 will light up:

1
	2
fa	new
	new

trimm er

7Series