Statement of Conditions

In the internal function, and/or reliability, NETGEAR reserves the right to make changes to the products described in this document without notice. NETGEAR does not assume any liability that may occur due to the use or application of the product(s) or circuit layout(s) described herein.

Federal Communications Commission (FCC) Compliance Notice: Radio Frequency Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1.This device may not cause harmful interference.

2.This device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: (1) Reorient or relocate the receiving antenna, (2) Increase the separation between the equipment and receiver, (3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected, (4) Consult the dealer or an experienced radio/TV technician for help.

Federal Communications Commission (FCC) Radiation Exposure Statement

To ensure compliance with the FCC's RF Exposure requirements for saftey, all omni-directional antennas (Netgear ANT24O5) must be installed to provide a separation distance of at least 20 cm from a person.

The panel antennas (Netgear ANT24D18) must be fixed mounted on a permanent structure to ensure a separation distance of at least 50 cm from all people. The panel antennas can only be used for point-to-point applications and may not be used for point-to-multipoint applications.

The antennas shall not be co-located with other transmitting devices.

Note: To meet FCC regulations, the system must be installed as shown in the diagrams. Substitution of cables and access point provided and/or any modification to any of the components of this system will void the user's right to operate it.

Check http://www.NETGEAR.com/go/antennas_fcc for a list of FCC approved antennas.

Use of this booster with any other devices is strictly prohibited by the FCC.