16ENGLISH
C 6 | Open Razor Head assembly again and |
| leave open to air dry. |
NOTE: Do not wipe or dry the shaving heads | |
with a towel or tissue.This could damage the | |
shaving heads. | |
C 7 | If the shaving unit becomes detached from |
| the razor, you can easily reattach it. |
8 | You may also clean the hair chamber |
| without water by using the supplied brush. |
Once A Month: Razor Heads
Do not mix up the cutters and combs as the shaving performance may be adversely affected for several weeks before optimal shaving performance is restored.
1Turn razor OFF, remove the charging plug
| from the outlet and cord from the razor. |
C 2 | Press the razor head release button to |
| open the razor head assembly. |
C 3 | Turn the wheel counterclockwise (1) and |
| remove the retaining frame (2). |
ENGLISH 17
C 4 | Remove and clean one set of cutters and |
| combs at a time. |
C 5 | Separate the cutter from the comb and |
| rinse clean under hot water. |
Do not clean more than one cutter and comb at a time, since they are all matching sets. If you accidentally interchange the cutters and combs, it could take several weeks before optimal shaving performance is restored.
C 6 | Replace the set back into the Razor Head |
| Assembly so that the “wings” on the comb |
| fit within the brackets located towards the |
| center of the Assembly. |
The set will only fit into the Razor Head Assembly if the ‘wings’ are between the brackets. Make sure that the two pointy edges of the head fit exactly into the recesses.
7Repeat the process for the other two sets of cutters and combs.
8Replace the frame.
C 9 Press down (1) and turn wheel clockwise
(2) until it locks into place.
10 Close the Razor Head Assembly.