10ENGLISH
4Remove and clean one set of heads at a time.
C 5 Separate the cutter from the comb and rinse clean under hot water.
◗ Do not clean more than one cutter and comb | |
at a time, since they are all matching sets. If you | |
accidentally interchange the cutters and combs, | |
it could take several weeks before optimal | |
shaving performance is restored. | |
C 6 | Replace the set back into the Head |
| Assembly in such a way that the sides with |
| the little holes point to the middle of the |
| shaving unit. |
◗ Make sure that the two pointy edges of the | |
head fit exactly into the recesses. | |
7 | Repeat the process for the other two sets |
| of cutters and combs. |
8 | Replace the frame. |
C 9 | Press down and turn wheel clockwise until |
| it locks into place. |
10 | Replace the Razor Head Assembly back on |
| razor. |
◗If the razor heads have been properly inserted, a shiny circle is visible in the middle of the razor head assembly.
Once A Month: Razor Heads
◗ For optimum performance, razor cutters and
ENGLISH 11
combs should be cleaned in a degreasing liquid (e.g. Norelco Razor Cleaner, Model RC1776, or alcohol) and lubricated with Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head).
Every Six Months:Trimmer
1Turn razor OFF.
2Push Trimmer Slide Switch up to pop up Trimmer.
C 3 Clean Trimmer with the brush.
C 4 | Lubricate the Trimmer teeth with Norelco |
| Razor Lubricant (model AL80) or with one |
| drop of mineral oil. |
5 | Close Trimmer by sliding Trimmer switch |
| down. |
This razor has no other | |
Any other service should be performed by an | |
Authorized Norelco Service Location. | |