16ENGLISH
Once A Month: Razor Heads
◗Do not mix up the cutters and combs as the shaving persormance may be adversely affected for several weeks before optimal shaving performance is restored.
1 Turn razor OFF, remove the charging plug from the outlet and cord from the razor.
C 2 Press the razor head release button (1), open and lift off the razor head assembly (2).
C 3 | Turn the center wheel counterclockwise |
| (1) and remove the retaining frame (2). |
4 | Remove and clean one set of cutters and |
| combs at a time. |
C 5 | Separate the cutter from the comb and |
| rinse clean under hot water. |
Do not clean more than one cutter and comb at a time, since they are all matching sets. If you accidentally interchange the cutters and combs, it could take several weeks before optimal shaving performance is restored.
C 6 | Replace the set back into the Head |
| Assembly so that the ‘wings’ on the comb |
| fit within the brackets located towards the |
| center of the assembly. |
ENGLISH 17
◗The set will only fit into the Razor Head Assembly so that the ‘wings’ on the comb fit within the brackets located towards the center of the assembly.
◗Make sure tat the two pointy edges of the head fit exactly into the recesses.
7 | Repeat the process for the other two sets |
| of cutters and combs. |
8 | Replace the frame. |
C 9 | Press down (1) and turn wheel clockwise |
| (2) until it locks into place. |
10 | Replace the Razor Head Assembly back on |
| razor. |
◗If the razor heads have been properly | |
inserted, a shiny circle is visible in the middle | |
of the razor head assembly. | |
Once A Month: Razor Heads
For optimum performance, razor cutters and combs should be cleaned in a degreasing liquid (e.g. Norelco Razor Cleaner, Model RC 1776, or alcohol) and lubricated with Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head).This helps prevent wear of the shaving heads.