Charging
Charge the Trimmer fully before you start using it for the first time or after a long period of disuse. This Trimmer will not operate corded directly from the electric outlet.
To Charge / Recharge
◗(Re)charging requires 10 hours.
◗Use only the cord provided.
◗Battery performance is best if you recharge only when the battery is (almost) completely empty.
◗Charging or recharging at temperatures below 40°F or higher than 95°F adversely affects lifetime of battery.
◗Continuously recharging Trimmer will reduce life of battery.
1Be certain Trimmer is OFF (fig. 1).
2Connect cord to Trimmer. Plug into any 120V AC outlet. Use only the cord provided (fig.2).
◗An adaptor plug may be necessary for cord usage in some foreign countries. Use an attachment plug adaptor of the proper configuration for power outlet.
Do not charge Trimmer for more than 24 hours.
3Green Charging Indicator Light on the adaptor will go on to indicate the Trimmer is charging (fig. 3).
It will take approximately 10 hours to fully charge the battery.
4Disconnect the cord and unplug from electrical outlet.
Optimize The Working Life Of The Battery
◗After Trimmer has been charged for the first time, do not recharge Trimmer between trimming sessions. Continue using it until the battery is completely empty.
◗Discharge the battery completely twice a year by letting the motor run until it stops.
◗Do not charge for more than 24 hours.
◗Do not keep cord permanently plugged in.
◗If Trimmer hasn’t been used for a long period of time,Trimmer must be recharged for 10 full hours.
1
2
3
Cordless Trimming
Charge according to directions. Unplug Trimmer from outlet and remove cord.
Slide ON/OFF switch ON to begin trimming.
If the battery is empty and you want to trim your beard, charge the Trimmer for at least 90 minutes and you will have enough power for one use (10 minutes).
Trimming
◗Use this Trimmer for its intended household use as described in this manual.
◗Always comb the beard and/or moustache with a fine comb before you start trimming.
◗If you are trimming for the first time, be careful. Do not move the Trimmer too fast. Make smooth and gentle movements.
Trimming with AccuControl
Guide Comb Attachment
◗Guide Comb Attachment must be on Trimmer in order to use the Zoom Lock.
1Turn the Zoom Lock to the desired trimming length setting (see table).The setting will appear in the window below the Zoom Lock (fig.4).
◗If you are trimming for the first time,start by using the maximum trimming length setting (#9) to prevent accidentally trimming hairs too short. As you become familiar with the settings, adjust Zoom Lock to desired trimming length. Zoom Lock will “click” into position at each setting.
2Switch the Trimmer ON.
3To trim in the most effective way, move the Trimmer against the direction of hair growth. Make sure the surface of the Guide Comb always stays in contact with the skin (fig. 5).
NOTE: Since all hairs do not grow in the same direction, you may want to try different trimming positions (i.e., upwards, downwards, or across). Practice is best for optimum results.
4If cut hairs have accumulated in the Guide Comb, turn Trimmer off, remove the Comb Attachment and blow and/or shake the hair out of the comb.The selected trimming length setting will not change when you do this (fig. 6).