Features
APatented AccuControl System with Removable Guide Comb Attachment
BSelected Hair Length Setting Window
CPrecision Patented Zoom Lock with 9
D
EOn/Off Switch
FCharging Indicator Light on Adaptor
GCleaning Brush
Full
Trimming Length Settings Table
#1 Stubble Length or Closely Cropped | .06 in./1.5 mm | |
#2 | Short | .1 in./2.5 mm |
|
|
|
#3 |
| .16 in./4 mm |
|
|
|
#4 |
| .22 in./5.5 mm |
|
|
|
#5 | Medium | .3 in./7.5 mm |
|
|
|
#6 |
| .38 in./9.5 mm |
|
|
|
#7 |
| .48 in./12 mm |
|
|
|
#8 |
| 0.60 in./15 mm |
|
|
|
#9 | Long | .72 in./18 mm |
|
|
|
Trimming For “Stubble” Look
1Be certain Guide Comb is on Trimmer and use setting #1 to result in a “stubble” look (fig. 7).
Trimming Without Guide Comb Attachment
Remove Guide Comb Attachment if you are:
◗Defining hair lines
◗Trimming nape of neck
◗Removing single, unwanted hairs
1Be certain Trimmer is in the OFF position.
2Remove the Guide Comb Attachment by pulling it off the Trimmer (fig. 8).
Never pull off the Guide Comb Attachment by grasping the flexible top portion. Always pull off by the bottom part of attachment.
3Switch the Trimmer ON.
4Make
Replacing Guide Comb Attachment On Trimmer
1Be certain Trimmer is in OFF position.
2Replace Guide Comb Attachment until it “clicks” into position.The Guide Comb Attachment can be placed on Trimmer only one way. If it does not fit properly, reverse it.
NOTE:The Zoom Lock can be on any setting when removing or replacing Attachment.
Cleaning
◗Always switch Trimmer OFF before cleaning.
◗Do not use abrasives, scourers or liquids such as alcohol, benzene, bleach or acetone to clean the Trimmer.
◗Never clean, remove or replace Guide Comb Attachment with motor ON.
◗Do not apply pressure to cutters.
◗Do not touch cutters with hard objects as this may damage them.
◗Do not use while bathing, showering or immerse the Trimmer in water or other liquids as damage to Trimmer may occur.
During Use:
◗If cut hairs have accumulated in the Guide Comb area, turn Trimmer off, pull Guide Comb Attachment off Trimmer and remove hairs by shaking and/or blowing.
Once A Week:
1
2
3
4
5
Make sure the Trimmer is switched OFF and disconnected from the electrical outlet.
Remove the Guide Comb Attachment.
Open the cutting unit (fig. 10).
Clean the cutting unit and the inside of the Trimmer with the brush supplied (fig. 11).
Close the cutting unit by pushing it back into place on the Trimmer until you hear a click (fig. 12).