16English
ProblemSolution
The appliance does not Remove the plug from the wall outlet and reinsert it. If you reinsert the respond when I try to plug within approximately 15 minutes, the appliance remembers all set different functions. settings. If you reinsert the plug after a longer period of time, the
appliance will go back to factory settings.You need to set all functions again.
| English 17 |
Problem | Solution |
The light wakes me too | Perhaps the appliance is positioned at a lower level than your head. |
late. | Make sure the appliance is located at a height at which the light is not |
| blocked by your bed, comforter/blanket or pillow. Also make sure the |
| appliance is not placed too far away. |
| Perhaps the appliance is not suitable for the voltage to which it is |
The lamp does not go on when the alarm goes off.
The lamp does not go on right away when I switch it on.
I do not hear the alarm sound when the alarm goes off.
The radio does not work.
Perhaps you set a light intensity level that is too low. Increase the light intensity level.
Perhaps you switched off the alarm by setting the control lever to the top position.To switch on the alarm, set the control lever to the middle position.
It takes approx. 1 second for the lamp to go on.This is normal, the lamp needs to heat up.
Perhaps you set a sound level that is too low.To set a higher sound level, see chapter ‘Using the appliance’, section ‘Radio/volume’.
Perhaps you switched off the alarm by setting the control lever to the top position.
Switch on the radio after you switch off the alarm to check if the radio works. If it does not work, call
Call
connected. Make sure that the voltage indicated on the appliance |
corresponds to the local voltage. |
The radio produces a crackling sound.
The alarm went off yesterday, but it did not go off today.
The alarm did not go off 9 minutes after I pushed the control lever down to snooze.
The light wakes me too early.
Perhaps the broadcast signal is weak. Adjust the frequency (see chapter ‘Using the appliance’ section ‘Radio/volume’) and/or change the position of the antenna by moving it around. Make sure you have unwound the antenna completely.
Perhaps you switched off the alarm by setting the control lever to the top position.
Perhaps you set a sound level and/or light intensity level that is too low. Set a higher sound and/or light intensity level.
Perhaps there was a power failure that lasted more than approximately 15 minutes. In this case the appliance goes back to factory settings.You need to set all functions again.
Perhaps you pushed the control lever down with so much force that it jumped to off position.
Perhaps you set the volume level to OFF.
Perhaps the light intensity level you have set is not appropriate for you. Try a lower light intensity level if you wake up too early. If light intensity 1 is not low enough, move the appliance further away from the bed.