Oregon Scientific RMR182 user manual EC-DECLARATION of Conformity, Etsi EN 300 220-3 Ver1.1.1

Page 13

EC-DECLARATION OF CONFORMITY

This product contains the approved transmitter module that com- plies with the essential requirements of Article 3 of the R&TTE 1999 / 5 / EC Directive, if used as intended and the following standards have been applied:

EN

Additional information:

The product herewith complies with the requirements of the Low Voltage Directive 73 / 23 / EC, the EMC Directive 89 / 336 / EC and carries the CE marking accordingly.

Safety of information technology equipment (Article 3.1.a of the R&TTE Directive)

Applied Standard

EN 60950: 2000

Electromagnetic compatibility (Article 3.1.b of the R&TTE Directive)

Applied Standards

ETSI EN 301 489-1-3 (Ver.1.4.1) : 2002-08

Efficient use of radio frequency spectrum (Article 3.2 of the R&TTE Directive)

Applied Standards

ETSI EN 300 220-3 (Ver1.1.1) : 2000-09

Carmelo Cubito

Agrate Brianza (MI) / Italy January 2004

Manufacturer’s EU R&TTE Representative

COUNTRIES RTTE APPROVAL COMPLIED

All EC countries, Switzerland CH

and Norway N

13

RMR182_EN

13

8/16/04, 2:58 PM

Image 13
Contents Introduction Main Features Main UnitFOUR-LINE LCD Display Before YOU Begin Main Features Remote UnitBattery Installation Main Unit Reset Button HOW to USE the Table Stand Or Wall MountingGetting Started Temperature Trend HOW to Check Remote Indoor TemperaturesMaximum and Minimum Temperatures Disconnected Signals HOW to Read the Kinetic Wave DisplayTransmission Collision Calendar Clock Display Modes About Radio Reception HOW to SET and ARM the Alarms HOW to SET the Clock ManuallyHOW to Stop AN Alarm Time Zone and Offset Table PrecautionsTemperature Measurement SpecificationsAbout Oregon Scientific Etsi EN 300 220-3 Ver1.1.1 EC-DECLARATION of ConformityOregon Scientific. All rights reserved RMR182EN