HoMedics TT-201, TT-200 warranty Memory Recall, HOW to Take a Temperature Reading

MEMORY RECALL

This thermometer will automatically store the last 10 measurements in memory. The most recent reading will automatically display when the unit is turned on. Each new temperature reading will also be entered into the memory as the most recent record.

When in memory mode, an arrow in the upper left corner will appear with the memory record number to the right as shown in the illustration below.

3.When the ear thermometer is ready, the display will next show the results of the most recent reading. The unit is ready for measurement at this point (Figure 2).

Figure 2

Indicates a

°

memory

reading

Indicates memory reading and number

°

4.Press and release the “SCAN” button again with the ear thermometer outside of the ear.

In DAY MODE: An arrow symbol will appear on the display (Figure 3).

Press “MEM” to cycle through the records from number 0 (the most recent reading) to number 9.

Note that when memory is at capacity, the oldest record will be

In NIGHT MODE: In addition to the arrow symbol, the flashlight will turn on for approximately two seconds.

deleted to make room for a new reading.

Memory will be cleared as a result of battery removal or power failure. A default reading of 00.0°F (00.0°C) will be displayed when memory is cleared until a new temperature reading is taken.

Figure 3

°

Indicates measurement in progress

HOW TO TAKE A TEMPERATURE READING

1.Always make sure that the waterproof probe has been cleaned with a cotton swab moistened with alcohol since its previous usage.

2.Press and release the “SCAN” button on the top of the device. All display symbols will appear for approximately one second

(Figure 1).

Figure 1

°

°

5.Insert the probe tip of the ear thermometer into the ear canal within two seconds (Figure 4). It is important that the probe tip be well positioned within the ear canal. Measurement time for the actual reading is approx. one second.

Figure 4

7 8