SENSOR'S | SENSOR'S |
|
|
SHIELD | RED |
| Note: |
WIRE | WIRE |
| |
|
|
| Light and |
|
|
| Power |
|
|
| Switches |
|
|
| Are Not |
|
|
| Included. |
TO |
| LIGHT | |
TEMPERATURE |
| SWITCH | |
SENSOR |
|
|
|
| WHITE | POWER | |
|
| SWITCH | |
|
| FUSE | |
|
|
| |
| RED |
|
|
| BLACK |
|
|
|
|
| 12 VOLT |
|
|
| BATTERY |
SENSOR CONNECTIONS
Mount the temperature sensor in a location that allows contact with the water at all times. The illustration below shows a typical location. Once a suitable place is found, mount the sensor to the hull with two #8 stainless steel screws. (not included) Route the sensor cable to the 3001. Do not cut the cable if it is too long! Coil and store it out of the way.
Attach the sensor wires to the 3001 using the supplied screws and washers. Make certain to attach the sensor’s wires to the 3001 according to the diagram shown below. If the wires are reversed, no damage to the unit will occur, but it won’t work properly. The 3001 is now ready for use.
3