HOW TO TAKE A TEMPERATURE READING
1.Install the probe cover on the probe.
(A probe cover was installed at time of purchase.)
Mate the probe cover groove with the protrusions on the thermometer.
2. Press the START button. The display indicates all the symbols, the previous reading, and finally “00.0ºC ” with the READY mark 
on. Now the thermometer is ready to measure temperature.
NOTE: Do not keep pressing the START button. Press and release it immediately.
3. Insert the thermometer gently into the ear. Always insert the thermometer into the same ear with the same direction and depth. (See “HOW TO INSERT THE THERMOMETER INTO THE EAR” on page 7.)
After seconds, you hear the beep sound that tells you the end of measurement. Gently remove the thermometer from the ear. Read the measurement on the LCD panel. At this time, the READY mark 
is flashing.
4. After about ten seconds, the READY mark 
turns off. To measure again, press the START button once. You may take a second reading immediately.
LifeSource Health Line | 8 |