Whirlpool 015-0005 Cleaning and Maintenance, Do not wax surfaces where you walk or stand

Page 14

Your Eljer whirlpool is designed to give you many years of pleasure with reasonable care and maintenance.

Your new acrylic bathtub is tough, durable and easy to care for. The colors have been formulated to match other

Eljer fixtures and enhance your choice of bathroom decorations. The high gloss surface will retain its lasting luster with proper care and maintenance.

CLEANING AND MAINTENANCE:

Always fill the tub with temperate water. Excessively hot water (greater than 130˚ F) may cause surface damage.

Remove bath mat after use and hang to dry. Allowing bath mat to dry in the tub may cause surface damage.

Clean after use with a mild liquid household detergent cleaner. Do not turn on jets when such cleaners are present.

Do not use: Lestoil® Cleaner; Lysol® Disinfectant (spray or concentrate); or Lysol® Basin, Tub and Tile Cleaner; Windex® Cleaner; Mr. Clean® Cleaner; Dow® Disinfectant Bathroom Cleaner*; or other cleaning products in aerosol cans.

HARSH CHEMICALS, SHARP AND ABRASIVE OBJECTS

SHOULD NEVER BE USED ON ACRYLIC SURFACES

Do not use wire brushes, knives or sharp objects to remove stains or other surface blemishes.

Use of abrasive cleaners or powders will dull the surface. If the glossy surface loses its sheen, dulled areas can be partially restored by rubbing with a white automotive body polishing compound and waxing with a liquid wax.

Do not wax surfaces where you walk or stand.

Do not allow nail polish remover, acetone, dry-cleaning fluid, paint remover, or other solvents to come into contact with the surface.

Clean the surrounding surface immediately after using caustic drain cleaners.

Do not permit drain cleaner to enter circulation system.

• Burning cigarettes will irreparably damage the surface of the whirlpool.

CLEANING/PURGING THE CIRCULATION SYSTEM

Once every month the circulating system must be purged and cleaned. Follow the steps outlined below:

1.Fill whirlpool with warm water and add two teaspoons of powdered automatic dishwasher (not laundry) detergent and one-half cup of household bleach to filled whirlpool.

2.Activate whirlpool system in accordance with operating instructions and run system for two minutes.

3.Drain and refill whirlpool with cold water. Circulate for five minutes.

4.Drain whirlpool completely after step 3 (above) is completed.

For Troubleshooting and Repair Parts please log on to www.eljer.com

*Lestoil® is a registered trademark of The Clorox Company. Lysol® is a registered trademark of The Linden Company. Windex® is a registered trademark of S.C. Johnson and Son, Inc.

Mr. Clean® is a registered trademark of The Proctor and Gamble Company. Dow® is a registered trademark of The Dow Chemical Company.

754764-100 Rev. A

14

Image 14
Contents Premiere Whirlpool Installation Table of Contents Important Safety Instructions Installation and Framing Instructions Installation and Framing Instructions Suggested Whirlpool / Bath Installation Method Typical Flange Mounting DetailSpecifications General Specifications for Eljer Whirlpools and Bath TubsMadison Model ROUGH-IN ReferencesCypress Model Canterbury Model Triangle ModelROUGH-IN References Emblem Model Emblem Total Massage Model Patriot Model 015-0309/0305Electrical Diagram Read and Follow ALL Instructions Total Massage Whirlpools Control PAD Pump Flow Variable Timer Valve Blower HeaterTotal Massage Circuit with Optional Heater AMP GfciOperating Instructions Cleaning and Maintenance Do not wax surfaces where you walk or standCanada