Silver Star 130 manual Electrical Wiring Connections

Page 13

I I I . I N S T A L L A T I O N

4.Connect the short black (ground) wire to a clean, bare metal area of the vehicle using the 12 mm (1/2 in.) sheet metal screw provided. Mount to an area close to the base of the lift. This allows adequate slack in the wire to make the harness connections.

"Drill a 1/16-in. pilot hole where the ground wire will be attached to the vehicle.

"Insert the screw through the ring at the end of the black (ground) wire and install the screw into the pilot hole.

WARNING! DO NOT attach the black (ground) wire to the lift.

5.Connect the harness of wires leading to the battery and ground to the harness that extends from the motor housing (black to black and red to red).

MOTOR HOUSING

BLACK - RED

POWER

BLACK (GROUND) WIRE ATTACH TO CLEAN, BARE METAL IN CLOSE PROXIMITY TO LIFT

FUSE

25-AMP

HARNESSES

SHEET METAL SCREW

12 MM (1/2”)

ROUTE RED (+) POWER WIRE

CONNECTOR

AUTOMOBILE

TO BATTERY

(USE PLIERS OR CRIMPING

BATTERY

 

TOOL TO CRIMP)

 

Figure 12. Electrical Wiring Connections

SilverBoom 130

13

Page 12 Page 14
Image 13
Page 12 Page 14
Contents SilverStar F E T Y G U I D E L I N E S III N T E N T SInternet and Private Purchases PURCHASER’S Agreement N T R O D U C T I O NInformation Exchange Pride Owners Club S a F E T Y Product Safety SymbolsLifting Capabilities InstallationLifting NON Pride Items Prelift InspectionDetermine L-BASE Location I . InstallationVehicles with Trunks Vehicles with Hatchbacks Mini VANS, Station WAGONS, ETC Assembling the LiftBoom ARM Adjustment Split Ring Collar AdjustmentBase Installation Securing The L-Base Base Cap Electrical Wiring InstallationElectrical Wiring Connections Lifting the Mobility Product O P E R a T I O NHas been found when using a C-arm Lift will not Operate TroubleshootingLift Stops Operating Warranty Exclusions ONE Year Limited WarrantyW a R R a N T Y INFMANU3530
Top Page Image Contents