3. Test Installation.
A. Raise and lower seat to make sure seat moves freely.
B. When seat is raised parallel to the wall, it will remain in this position until lowered (see Figure 2).
C. Examine seat, fasteners, Mounting Flanges, Baseplate, and Guide Bracket to make sure there are no loose fastenings.
How to Reverse Shower Seat. The solid phenolic shower seat surface may be positioned on the stainless steel frame with the lon- ger
If repositioning the seat surface before installation of the unit on the wall; place entire unit on a horizontal surface; remove carriage bolts and acorn nuts (4); turn seat over reversing position of long and short ends; reinstall carriage bolts and acorn nuts.
If repositioning the seat surface after the unit has been installed on the wall; lower folding seat to horizontal position; remove carriage bolts and acorn nuts (4); turn seat over reversing position of long and short ends; reinstall carriage bolts and acorn nuts.
Important Notes: Support square frame tubes when loosening and removing carriage bolts and acorn nuts; the square frame tubes may separate from the round tubes that support the solid phenolic shower seat. If square and round frame tubes come apart when solid phenolic shower seat is removed, reassemble by placing round frame tube ends in the round holes on the sides of the square frame tubes.
OPERATION:
Shower seat folds up against wall when not in use. The spring at the top of the Baseplate holds seat in upright position until released by pulling the top of the seat away from the wall. Mounting Flanges and Guide Bracket allow for varying mounting heights and leave the floor clear for easy cleaning. Nonporous solid phenolic seat has slots to permit water to drain, does not splinter or require oiling, and will not support growth of bacteria. Slotless
Figure 3
Mounting Flange (2) |
Drywall |
(1/2'' Thick) |
Tile |
(1/4'' Thick) |
Guide |
Bracket |
Backing |
in Wall |
Baseplate |
Bushing |
(Stainless Steel) |
0.257'' Inside Diameter |
Protrudes 1/16'' Minimum Above Tile |
(2 Required at Bottom of Bracket) |
Fastener |
Recommended |
Hole Size |
for Screw |
7/32'' Dia. |
Apply Silicone |
Around Bushings and |
All Fasteners to Seal |
NOTE: Bushings (2) are not furnished by manufacturer.
©2007 by Bobrick Washroom Equipment, Inc. Form No.
In the U.S.A.: BOBRICK WASHROOM EQUIPMENT, INC.
200 Commerce Drive, Clifton Park, New York
11611 Hart Street, North Hollywood, California
100 Bobrick Drive, Jackson, Tennessee
In Canada: BOBRICK WASHROOM EQUIPMENT COMPANY
45 Rolark Drive, Scarborough, Ontario M1R 3B1 • Tel: (416)