3.2Removing/Installing the Cushion Covers
WARNING
The covers are designed to protect the foam from moisture and to provide fire retardency. DO NOT use the cushion without either the inner or outer cover. If the covers are torn, they MUST be replaced IMMEDIATELY.
ThinAir Bladder
Cover
Cushion
Zipper
Removing the Cover
DO NOT remove both the outer cover and inner cover at the same time, otherwise damage to the inner cover material may occur.
1.Remove the cushion from the seating surface. Refer to Attaching/Removing the Cushion To/From the Seating Surface on page 3.
2.Unzip the outer cover.
3.Remove cushion, still inside the inner cover, from the outer cover.
4.Unzip the inner cover.
5.Remove the cushion from the inner cover.CAUTION
Installing the Cover
1.If the inner cover has been removed, position the cushion with the ThinAir bladder toward the rear of the inner cover.
The back surface of the cushion is marked “REAR”.
2.Slide the cushion into the inner cover.
3.Zip the inner cover closed.
4.Position the cushion with inner cover and the ThinAir bladder in place toward the rear of the outer cover.
When installed properly, the ThinAir bladder is at the top of the inner cover. The zipper is at the rear and the stretch fabric is at the top of the outer cover.
5.Slide the cushion into the outer cover.
6.Zip the outer cover closed.
Use care not to snag the inner cover in the outer cover zipper, or damage to the inner cover will occur.
7.Reattach cushion onto seating surface. Refer to Attaching/Removing the Cushion To/From the Seating Surface on page 3.CAUTION
Part No 1167615 | 5 | Invacare® Matrx® Stabilite™Cushion |