Trucklift | Safety Instructions |
1.2Further Information
At installation pay attention to the following:
Standard lifting platforms may not be operated in washing halls, rooms with high humidity or outdoors! The lifting platform must be protected from any form of water splashing! Never
äclean the lifting platform with high pressure cleaners or steam cleaners!
In rooms with very low ceilings it is recommended to install a ceiling light barrier. This can be ordered from the manufacturer.
For safe operation pay attention to the following:
Read the standard operating procedures and user`s manual thoroughly! MAHA will not accept and is not liable for any claims for damage or service costs incurred due to non- compliance with these operating instructions.
All official Accident Prevention Regulations must be thoroughly complied with!
Damages to
Keep the lifting platform and the surrounding work area clean.
Do not deposit any parts on the support arms or on the driving platform.
The vehicle should be driven slowly onto the lifting platform to avoid putting any unnecessary strain on vehicle and lifting platform.
On lifting platforms equipped with an axle jack pay close attention that no objects are below the axle jack.
Balancing work on the lift while the platform is being loaded is forbidden. The vehicle may roll off the driving platform.
äPull the parking brake of the vehicle after entering the lifting platform.
All work done on impulse sensors and proximity switches should be carried out by trained electricians.
1.3Safety Features
The TRUCKLIFT is equipped with the following safety features:
Electronic lift synchronisation monitoring. This system monitors all the lifting carriages and ensures that they are synchronised during lifting and lowering. If one carriage blocks all the drive motors are switched off automatically.
Electronic bearing nut monitoring system on all four columns. If a bearing nut breaks the system only permits the unit to be moved to its lower starting position.
Bearing nut wear indicator, lets you know in good time when the bearing nuts need to be replaced.
Drive belt breakage safety system on all four columns. All motors are switched off automatically if a drive belt is defective.
Motor overload protection system on all four columns.
äCatch nuts, which support the load on the lift in the event of failure of the bearing nuts.
The main switch doubles as an emergency off switch. In an emergency, the unit can be switched off by turning the switch to position 0.
2 | D1 |