E&J EJ777-2 FOOTREST-DETACHABLE, Swingaway, Remove footrest for transfer see picture at right

Page 15

FOOTREST—DETACHABLE, SWINGAWAY

WARNING: Do not stand on the footplates; this could cause the Transport Chair to tip.

Remove footrest for transfer (see picture at right)

1.Pull swingaway release lever toward front of Transport Chair and swing footrest outward.

2.Lift footrest straight up off Transport Chair hinge pins.

Attach footrest (see picture at right)

1.Set footrest on outside of Transport Chair so that footrest hinge plates engage Trans- port Chair hinge pins.

lower hinge pin

release

 

lever

lower hinge plate

swingaway footrest

2.Swing footrest inward until release lever locks into place. Ensure that swingaway release lever is locked in place.

WARNING: Ensure that footrests are locked in place before occupying or operating Transport Chair.

Adjust footplate extension length

Tools required: included wrench

There is a draw bolt in the bottom of the footplate extension tube that allows the footplate extension to be repositioned upward or downward in the foot- rest hanger. To lengthen or shorten footplate exten- sion:

1.Loosen, but do not remove, the draw bolt using the included wrench.

2.Reposition the footplate extension at the desired position.

3.Resecure the draw bolt using the included wrench.

4.Follow steps 1-3 to adjust other footplate exten- sion length. Ensure that footrest bolts are secure- ly fastened, and that minimum ground clearance is 2 1/2 inches.

footrest hanger

footplate extension

footrest

footrest hanger

footplate extension tube

draw bolt

footplate

WARNING: The footplates' lowest point should be no closer to the ground than 2 1/2 inches, to permit proper clearance.

WARNING: Ensure that footplates are securely clamped before occupying or operat- ing Transport Chair.

EJ777-2-INS-LAB-RevA10EJ777-2 Transport Chair

15

Image 15
Contents EJ777-2 Bariatric Transport Chair Contents Intended USE IntroductionStatements of Significance EJ777-2 Transport Chair Labels Important Safety PrecautionsEJ777-2-INS-LAB-RevA10 EJ777-2 Transport Chair Component Identification OperationHandling Tips Transfer Activities Ramps and Inclines For attendant curb ascent facing backward For attendant curb ascent facing forwardFor attendant curb descent Tighten crossbraces AdjustmentsRear Wheel & Caster CrossbraceARM Rotate arm up for transfer see pictures belowArm, locked Arm, unlocked Arm, rotated Attach footrest see picture at right Adjust footplate extension lengthFOOTREST-DETACHABLE, Swingaway Remove footrest for transfer see picture at rightFor attendant attendant wheel locks, temporary lock Attendant Wheel LocksTransporting the EJ777-2 Transport Chair Preparing the EJ777-2 for TransportFold the Transport Chair see picture above Store Transport Chair in cars back seat Store Transport Chair in cars trunkUnfold the Transport Chair see picture on previous Do-it-yourself maintenance MaintenanceList of tools General careCheck tire wear Check hand grips Check rear wheel adjustmentCheck wheel lock engagement Check anti-tippers optionalCheck footrests Cleaning your Transport ChairCheck arms Check backposts / push handlesSymptom TroubleshootingSpecifications EJ777-2 Bariatric Transport Chair Limited WarrantyEJ777-2-INS-LAB-RevA10 EJ777-2 Transport Chair Index
Related manuals
Manual 28 pages 31.08 Kb