6.Store Lamp in a safe location out of the reach of children.
NOT attached to the Frame and may pop out.
REPLACING THE BULB
When replacing the Lamp Bulb (5), be sure to wear ANSI- approved safety goggles. Also, keep track of the Screws (8) during replacement. The Screws are very small and can be swallowed by young children.
1.To replace the Bulb (5), turn off the Lamp and unplug the Power Cord (13) from the outlet.
2.Lie down the Lamp down and set the Adjusting Knob (9) so that the Lamp rests on the work area with the Bulb facing up.
Bulb 
Bulb Support Latch
Figure D
5.Pull up on the Bulb Support Latch (6). See Figure D, above.
Glass Frame
Screws
Glass Frame
Screws
Bulb
Bulb Socket
Figure E
Figure C
3.Use a #0 Phillips screwdriver (not included) to remove the five Screws
(8)from the Glass Frame (4). See Figure C, above.
4.Lift the Glass Frame (4) and Arm
(10)away from the Lens Frame (2). Please note: Be careful when mov- ing Lens and Lens Frame; the Lens is
6.Pull the Bulb (5) out of square Bulb Socket (7). See Figure E, above.
7.Properly dispose of old Bulb and at- tach new 4T 12W Energy Saving bulb to Bulb Socket (7).
SKU 97448 | For technical questions, please call | Page 5 |