Dell D10D, D50D, D90DW manual Installing D Class Flash, Requirements, Procedures

2 Installing D Class Flash

This chapter contains information for users of Wyse D class thin clients who must install new flash.

Requirements

•Small Phillips screwdriver

WARNING: Flash modules may be susceptible to damage by Electro-Static Discharge (ESD). All industry-standard cautions should be followed to avoid ESD. Before you remove or install a module, touch any metal part of the chassis and keep that contact with the chassis during the installation process.

Procedures

CAUTION: Follow all precautions listed in the Quick-Start Guide that came with your thin client for disconnecting and reconnecting the thin client.

1.Perform a proper shutdown of the thin client by closing all files and ending your session, and then pressing the power button to turn off the thin client.

2.Unplug the power cord and power adapter, and remove any other cables from the thin client, and detach the vertical foot.

3.Position the thin client horizontally, where the Wyse logo-side with four flat screws is facing downward. Using the Phillips Screwdriver, remove the three screws from the cover along the back panel edge as shown in Figure 2.

Figure 2 Removing the cover screws