Motorola XU2600, XV1100, XV2100, XU2100 Features, Programming the Interference Eliminator Code

Programming the Interference Eliminator Code
The Interference Eliminator Code helps minimize interference by
providing you with code combinations, which filter out static, noise,
and unwanted messages.		Interference
1.	Enter Programming Mode as necessary, refer to “Entering
	Programming Mode” on page 31.	Eliminator	0107
		Code
2.	Press \ until the Interference Eliminator Code display number
	begins to flash.
3.	Press [ or ] to select the desired Code (See “Interference Eliminator Codes”
	beginning on page 48).
4.	Press and hold M to exit k, or press \ to continue.

Assigning Channels to Presets (XU2600 and XV2600 only) Presets allow you to easily switch to more frequently-used channels.

1.Enter Programming Mode as necessary, refer to “Entering Programming Mode” on page 31.

2.Press [ or ] to select the desired channel.

3.Press and hold T or S to assign that channel to a preset, radio beeps to confirm. All of the channel settings are assigned to that preset button.

4.Press and hold M to exit k, or press \ to continue.

Programming Features

X

33

Programming the Scramble Feature (2-watt models only)

The scramble feature garbles the transmission for anyone listening without the same scramble setting. It does not guarantee confidentiality, but it increases privacy. The scramble feature is set individually for each channel.

	1.	Enter Programming Mode as necessary, refer to “Entering Programming Mode”
		on page 31.
Features	2.	Press \ until e displays.
	3.	Press [ or ] to select 1, 2, or 3. Factory default is set to Off: 0.
			e		0
		When you exit k, e displays.
	4.	Press and hold M to exit k.
Programming	Programming Bandwidth (when FCC allowable)
	Some frequencies have selectable channel spacing, which must
	match other radios for optimal radio quality. Bandwidth settings are		K	C
	programmed for each channel.
	1.	Enter Programming Mode as necessary, refer to “Entering
		Programming Mode” on page 31.
	2.	Press \ until K displays.
	3.	If D/C flashes, press [ or ] to select D (25.0 kHz) or C (12.5 kHz)

Xbandwidth. (See “Frequencies and Bandwidths” beginning on page 45). If D/C

does not flash, then you cannot select the bandwidth for this frequency.

34