Motorola XTS 3000 manual Belt-Clip Installation and Removal, Installing the Belt Clip

Page 12

Introduction

Belt-Clip Installation and Removal

Note

The battery must be removed from the radio before the belt clip can be installed or removed.

Installing the Belt Clip

1.Hold the battery in one hand so that the top of the battery faces upward and the back of the battery faces you.

2.Holding the belt clip in the other hand with its top facing upward, align the slide assembly on the back of the belt clip with the slots on the back of the battery.

3.Slide the belt clip downward toward the bottom of the battery until the belt clip “clicks” in place.

Slide

Assembly

Slots

Belt Clip

Battery

Removing the Belt Clip

1.Hold the battery (with belt clip installed) in one hand so that the top of the battery faces upward and the front (radio side) of the battery faces you.

2.At the top of the battery, press down on the belt clip’s metal tab and slide the belt clip upward until it disengages from the battery.

3.Continue to slide the belt clip upward until it is free from the battery.

Press

Down Metal Tab

8

Image 12
Contents Digital XTS 3000 Basic Model Notations Used in This Manual PrefaceCommon Radio Features General Radio OperationsSpecial Radio Features Computer Software CopyrightsAdditional Information Introduction InspectionProgrammable Switches and Buttons Radio ControlsProgrammable Features Switches, Buttons, Knobs, and Indicators Bicolor LEDAntenna Installation and Removal Radio Operating-Frequency TableAntenna Identification Table Battery Installation and Removal Installing the BatteryRemoving the Battery Belt-Clip Installation and Removal Installing the Belt ClipRemoving the Belt Clip Universal Connector Cover Installation and Removal Installing the Universal Connector CoverRemoving the Universal Connector Cover Introduction Turning the Radio On and Off Radio OnRadio Off Selecting a Zone and Channel Zone SelectionChannel Selection Adjust the Volume Control Knob for a Receiving/TransmittingGeneral Radio Features Time-Out TimerLow-Battery Indication Emergency Entering the Emergency StateCommon Radio Features PTT SwitchExiting the Emergency State Emergency Keep-AliveIndividual Calls Receive Only Answering an Individual Call Call ResponseButton Call Response ButtonRepeater Access PL DefeatRepeater/Direct Selecting Repeater or Direct OperationScan Turning Scan On and Off Deleting Nuisance ChannelsDynamic Priority Change Conventional Operation Only Selecting Squelch Operation Smart PTTSpecial Radio Features Dynamic RegroupingSelect Enable/Disable Reprogram RequestPress the Reprogram Request Button if programmed, see PTT-ID Transmit Secure Operation Selecting Secure or Clear TransmissionsManaging Encryption KEY LoadingSelectable Power-Level Trunking System Controls Busy OverrideDispatcher-Interrupt FailsoftOut-of-Range Site LockSite Change Glossary Alert Tones Sound Tone Name OccursHigh-Pitched Tone Battery Charging and Disposal Charging BatteriesRecycling or Disposal of Batteries Hanil Metal Recycle CO Helpful Tips Cleaning Radio CareHandling Air Bag Safety Information ServiceIndex Index General Radio Features Questionnaire Business Reply Mail FCC Safety Standards 68P81083C70 6881072C75