Toshiba SG-1701 owner manual Wall mount template

Page 9

•Route the cords through the guides.

•Place the base unit on the posts of the wall plate and push down until it is firmly seated.

•USE ONLY WITH Supplied AC ADAPTOR (TAC-2981; power source AC 120V, 60Hz/DC 9V).

Notes

•Do not use any outlet controlled by a wall switch.

•If you don’t have a standard wall plate, cut out the template below and use it to position two screws (minimum length of 1-3/8 inches) into the wall with the heads protruding about 3/16 inch.

CUT

CUT

Wall mount template

IMPORTANT:

•Before mounting, select a wall area of sufficient strength. If mounting on wallboard or in an area of questionable strength, locate a stud for maximum support of your telephone.

•Avoid electrical cables, pipes, or other items behind the mounting location that could cause a hazard.

8

Image 9

Contents SG-1701 Important Safety Instructions Rbrctm Seal Service Requirements Important Instructions to UsersFCC Requirements Introduction FeaturesSetting UP the Base Unit InstallationHandset for the first time Charge the Battery PackMounting on a Standard Wall Plate Wall MountingWall mount template Locations of Controls Handset ControlsBase Unit Controls Making a Call TONE/PULSE SettingMaking a Call Answering a CallChanging the Handset Speaker Volume Changing the Ringer VolumeUsing the Call Waiting SERVICE, ETC Interference or StaticMuting PagingOUT of Range Using a Headset option Using a Belt Clip option Storing Numbers Memory DialingErasing a Stored Telephone Number Dialing a Stored NumberInserting a Pause in Memory Chain DialingTroubleshooting Guide AccessoriesSupplied Accessories Optional AccessoriesTALK/BATT LOW TELEPHONE/TELEPHONE Answer Machine Limited Warranty WARRANTY/SERVICE