NetComm V100 manual Limitations of Warranty

Page 39

Limitations of Warranty

The Trade Practices Act 1974 and corresponding State and Territory Fair Trading Acts or legalisation of another Government ("the relevant acts") in certain circumstances imply mandatory conditions and warranties which cannot be excluded. This warranty is in addition to and not in replacement for such conditions and warranties.

To the extent permitted by the Relevant Acts, in relation to your product and any other materials provided with the product ("the Goods") the liability of NetComm under the Relevant Acts is limited at the option of NetComm to:

■Replacement of the Goods; or

■Repair of the Goods; or

■Payment of the cost of replacing the Goods; or

■Payment of the cost of having the Goods repaired.

All NetComm ACN 002 490 486 products have a standard 12 months warranty from date of purchase. However some products have an extended warranty option (refer to packaging). To be eligible for the extended warranty you must supply the requested warranty information to NetComm within 30 days of the original purchase by registering on-line via the NetComm web site at www.netcomm.com.au.

YML749Rev1

V100 User Guide

www.netcomm.com.au

39

Page 38 Page 40
Image 39
Page 38 Page 40
Contents
Page Contents YML749Rev1 V100 User Guide Introduction Understanding VoIP Minimum System Requirements Do I need a Micro filter? Package Contents V100 ATA Overview Front IndicatorsLabel Description Back PanelV100 Start Up Resetting the V100 ATA to its factory default settingsBefore continuing Installing the V100 ATAOption a Ethernet Adsl Internet Connection Connecting the V100 ATA to an Adsl Router/ModemOption B Optus/Telstra Cable Internet Connection Modem Internet accessInstalling the V100 ATA Utility Status Tab Using the V100 ATA Configuration UtilityUsed respectively Dhcp Connection Mode TabGateways address through which the V100 ATA communi Local SIP TabPhone Configuration Call Forward YML749Rev1 V100 User Guide Stun Tab Telephone Book Tab Reach. And the remote party must use this username to accept Diagnostic Tool TabSystem Upgrading the V100s Firmware V100 PPPoE Mode Appendix a Flow Chart of ConfiguringV100 Dhcp Mode V100 Fixed IP Mode WAN LED is off Appendix B TroubleshootingCannot get bi-directional conversation Appendix C Cable Connections RJ-45 Network PortsTwisted pair cables To RJ-11 adapter NetComm Contact Information Appendix D Registering your NetComm ProductCustomer Information Appendix E Legal & Regulatory InformationProduct Warranty Limitations of Warranty
Top Page Image Contents