GE 25893 manual Installing the Phone

Page 10

INSTALLING THE PHONE

1.Choose an area near an electrical outlet and telephone wall jack (RJ11C).

2.Plug the AC power supply into the electrical outlet and the DC connector into the power jack on the back of the base.

CAUTION: Use only ATLINKS, Inc. power supply 5-2605 that came with this unit. Using other power supplies may damage the unit.

3. Install the handset battery.

NOTE: You must connect the handset battery before use.

NOTE: Battery and battery door are packaged together inside a plastic bag and are separate from the handset.

•Locate the battery compartment on the back of the handset.

•Insert the battery pack.

•Plug the battery pack cord into the jack inside the compartment.

BATTERY

RED WIRE

PRESS DOWN

 

FIRMLY

BLACK WIRE

NOTE: It is important to maintain the polarity (black and red wires) to the jack inside the compartment as shown in the illustration

• Replace the battery compartment door.

4.Connect the telephone line cord by plugging one end of the telephone line cord into the jack on the back of the base and the other end into a telephone wall jack.

5.Set the RINGER switch (on the handset) to ON, and place the handset in the cradle on the base. The charge indicator on the base turns on to indicate the handset battery is charging.

6.Allow handset to charge for 16 hours prior to first use. If you don’t properly charge the handsets, battery performance is compromised.

10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents 25893 Equipment Approval Information Notification to the Local Telephone CompanyFCC RF Exposure Requirements Interference InformationHearing AID Compatibility Table of Contents on the following Handset Sound Signals Introduction Before YOU Begin Make sure your package includes the items shown hereHandset and Base Layout Installation Installing the Phone Answering System Setup Using the Base Sample Outgoing Announcement Answering System OperationTo erase one message at a time from the base Telephone SET UP To erase a message from the handsetTONE/PULSE Telephone Operation Caller ID CID Call Waiting Caller ID Deleting a CID Record Digit Memory Number For Advanced Features Remote Access Press this Button Belt Clip and Optional Headset Changing the Battery Handset Sound Signals Display ID MessagesLong Distance Answering System Display MessagesTroubleshooting Guide Caller ID Solutions Answering System Solutions General Product Care Causes of Poor ReceptionService Index Page Limited Warranty For how long after your purchase$5.00 Atlinks USA, Inc
Top Page Image Contents