OPERATING INSTRUCTIONS
SET UP
1.Open the cover of the battery compartment and insert four AA batteries. (Not included)
2.Connect the coiled cord to receiver and the telephone base.
3.Connect the telephone wire to the telephone set and wall jack
TONE/PULSE SELECTOR
Select the type of dialing that you desire or that your telephone system requires.
•TONE The unit will operate using tone dialing.
•PULSE The unit will dial using rotary dial type pulses.
RINGER VOLUME CONTROL
The volume control for the incoming call ringer is located on the right side of the phone console. Select the desired volume/function of the tone ringer:
• | OFF | indicates that the ringer volume is turned off and there will be no sound to |
|
| signal an incoming call. Note: the flashing light will indicate an incoming call. |
• | LO/HI | LO indicates the ringer volume will be diminished but can be heard. |
|
| HI indicates maximum ringer volume. |
SPEAKER (HANDS-FREE) VOLUME CONTROL
The volume control button for the speaker is located on the right side of the phone console. Slide the control from Min to Max to adjust the volume.
MAKING CALLS
1.Select the desired dialing mode with the Tone/Pulse selector. (Do this only once when you set up your phone.)
2.Select a phone line by pressing either the “LINE 1” or “LINE 2” button.
3.Pick up the receiver or press SPEAKER button and wait for a dial tone.
4.Dial your call.
RECEIVING CALLS
When the phone rings, the red light will flash which indicates that there is an incoming call.
1.Lift the receiver and speak into the mouthpiece.
2.Hang up the receiver to release the telephone line when the conversation is completed.
3