Volume Adjustment, Help | Lucent Technologies MDW 9030P guide

Volume Adjustment

To increase or decrease the volume of the handset alerter or the receiver (earpiece):

■Alerter: Press the "+" or the "–" button while the MDW 9030P is awake but turned off. If the display is dark (the phone is in "sleep" mode), press "to wake it up, then press the "+" or the "–" button.

■Receiver: Press the "+" or the "–" button while the MDW 9030P is turned on.

Battery Charger LEDs

The color of the battery charger's LEDs indicates the state of the corresponding battery pack, as shown in the following table:

	If it is the SPARE
	LED, the battery
Battery	pack in the Spare
charger	battery

LED shows... compartment...

	If it is the
	REFRESH LED,
If it is the	the Refresh button
HANDSET LED,	was pressed, and
the battery pack in	the Handset
the Handset...	battery pack...

Steady	Is charging	Is charging	N/A
orange
Steady green	Is fully charged	Is fully charged	N/A

Flashing red

*See note.

Steady red

Has one of the		Has one of the		N/A
following problems:		following problems:
•	Is not seated	•	Is not seated
	properly in the		properly in the
	charger		charger
•	Has dirty	•	Has dirty
	contacts		contacts
•	Is defective	•	Is defective

Is in the Discharge	Is in the Discharge	Is in the Discharge
portion of the	portion of the	portion of the
Refresh cycle.	Refresh cycle.	Refresh cycle.

*Note: If either the SPARE LED or the HANDSET LED is flashing red, both battery packs must be removed from the charger to clear the flashing-red condition. Address the possible problems for one battery pack at a time to determine whether one is bad.

Help!

If you need help when using your MDW 9030P with a PARTNER, MERLIN®, or MERLIN LEGEND® system in the continental U.S., call 1 800 628-2888. For all other systems, follow the procedure you normally use to get support for your communications system. Outside the continental U.S., contact your Lucent Technologies Representative or local Authorized Dealer.

- 3 -