Voice Function Setting, Flash Recall Setting

SETTINGS

Voice Function Setting

When the VOICE function is ON, in pre-dial mode numbers 0-9, numbers held in the call log, numbers held in the phone book and a caller’s name (if recorded, see Phonebook Chapter – Storing Name Recording) will be announced in the loudspeaker.

Press MENU

Use ▲ or ▼ to select VOICE

Press DIAL to select

Use ▲ or ▼ to select ON/OFF

Press DIAL to select

Press CID to exit

Flash (Recall) Setting

Many special telephone services, such as Call Waiting, require a switch hook signal. For example, if you have Call Waiting, you can put a call on hold and take a second incoming call on the same line by pressing CALL WAITING button. Press CALL WAITING again to alternate the between the two call.

Note: If you do not have any special phone services requiring a switch hook signal,pressing CALL WAITING might disconnect the current call.

Dialling Mode (Tone/Pulse) Settings

In the US, all telephone exchanges now use Tone dialing. If your phone does not dial out, it is probably being used from an older private switchboard (PBX). In this case, the Tone/Pulse setting must be changed to Pulse.