Mute Button, Automatic Memory, Volume Button

MUTE BUTTON

Press MUTE to speak without the person on the phone hearing your conversation. The MUTE Indicator will light up and remain lighted until you resume your conversation. Also, “MIC MUTED” will show in the display. To resume the conversation, press MUTE. The MUTE indicator will go out and your call can continue.

AUTOMATIC MEMORY

Storing A Number

1.Press SAVE, [SAVE TO?] appears on the display window.

2.Press the desired memory location. (M1-M5 or SHIFT M1-M5)

3.[ENTER NUMBER>] appears on the display.

4.Enter the desired number using the keypad (maximum of 24 digits). Press SAVE to confirm.

5.[ENTER NAME>] will appear. Type the name (16 characters max.) using the keypad. Use REVIEW UP to add a space. Use REVIEW DOWN to delete a character. Press SAVE again.

6.[SET VIP RING] will appear. Use REVIEW UP and REVIEW DOWN to select the desired ring cadence. Press SAVE again.

7.[MEMORY STORING] will show briefly.

Dialing A Number

1.Press the desired memory location (M1-M5 or SHIFT M1-M5)

2.The number will be displayed.

3.To dial the number, lift the handset, press SPEAKER or press DIAL.

VOLUME BUTTON

A built-in amplifier feature allows you to change the listening volume in the receiver of the handset when speaking with your party. Press VOLUME UP or VOLUME DOWN to achieve different levels. The volume remains the same between calls. It does not return to a nominal level.

REDIAL BUTTON

1.To redial one of the last 10 numbers dialed, press REDIAL. The display will show the last number dialed. To scroll through the last 10 numbers, press REVIEW UP or REVIEW DOWN. Note that if HIDE REDIAL NUM was selected during setup only the first 8 digits of the number will be displayed. The entire number will be dialed out when REDIAL is pressed.

2.After the desired number is selected, dial the number by pressing REDIAL again, lifting the handset, pressing SPEAKER or pressing DIAL.

3.The selected number (32 digits maximum) will be redialed.

PAUSE BUTTON

PAUSE allows you to insert a 3.6-second pause in the dialing sequence. This is particu- larly useful if you are connected to a PABX system where you must dial an access code (usually the number 9) to obtain an outside line.