Teledex C1100 series important safety instructions With the handset not on the base cradle

Page 6

PROGRAMMING THE HOTEL SERVICES DIRECT ACCESS KEYS

The CL1100 series has either six (model CL1106) or eleven (model CL1111) programmable hotel services direct access (or auto dial) keys (M1-M6/M11.) These keys can be pro- grammed to automatically dial telephone numbers or activate telephone system features. These keys can only be programmed from the base unit. To program the keys, follow these steps:

1)Connect the CL1100 series to a working telephone line.

2)Press the “SPEAKERPHONE” key. The speakerphone LED will illuminate.

3)Enter the target telephone number, including “PAUSE” as required. The number sequence can be up to 32 digits long, including PAUSE and FLASH.

4)Press the “STORE” key twice.

5)Press the auto dial key where the number is to be stored.

6)Press the “SPEAKERPHONE” key to disconnect. The speakerphone LED will go out.

RECEIVING A CALL

When the CL1100 series receives an incoming call, both the base and handset will emit an audible ringing tone. The message LED and the “ON” key LED on the handset will be flashing, following the ring cadence. To take the call:

with the handset not on the base cradle:

1)Pick up the handset.

2)Press the “ON” key to answer the call.

3)The “ON” LED will illuminate.

4)To end the call, place the handset on the base cradle, or press the “OFF” key.

with the handset resting on the base cradle:

1)Pick up the handset.

2)The handset will automatically answer the call and the “ON” LED will illuminate.

3)To end the call, place the handset on the base cradle, or press the “OFF” key.

USING THE SPEAKERPHONE

1)Press the “SPEAKERPHONE” key on the base unit. The speakerphone will answer the call. The “SPEAKERPHONE” LED will turn on to indicate that speakerphone is activated.

2)To end the call, press “SPEAKERPHONE” key again. The “SPEAKERPHONE” LED will turn off.

TO PLACE A CALL USING THE HANDSET

1)Press the “ON” key on the handset. The “ON” LED will illuminate.

2)Listen for dial tone, then dial the desired number.

3)To end the call, press “OFF” key. The “ON” LED will turn off.

TO PLACE A CALL USING THE SPEAKERPHONE

1)Press the “SPEAKERPHONE” key. The “SPEAKERPHONE” LED will illuminate.

2)Listen for dial tone, then dial the desired number.

3)To end the call, press the “SPEAKERPHONE” key again. The “SPEAKERPHONE” LED will turn off.

3

Image 6
Contents Important Safety Instructions CL1100 Series Users Guide CL1100 Series Telephone Diagram LEDTo Mute the Handset Charging the Battery With the handset not on the base cradle With the handset resting on the base cradleUsing the handset Preparing to USE the CL1100 Series Telephone