Redial, Adjusting the Handset Volume, Pause KEY

MUTE (SPEAKERPHONE-EQUIPPED MODELS ONLY)

1)To mute a call, press the MUTE key. The red MUTE LED will light. You will continue to be able to hear the other party, but they will not be able to hear you

2)Press the MUTE key again to turn off the mute feature. The MUTE LED will go out.

REDIAL

To redial the last telephone number dialed:

1)Lift the handset from the cradle, or press the SPEAKERPHONE key.

2)Press the REDIAL key. The last number dialed will be redialed.

ADJUSTING THE HANDSET VOLUME

To the left of the dialpad, locate the volume up/down arrow keys. While using the handset, either during an active call, or preparing to dial, press either the up or down key to raise or lower handset volume to the desired level.

PROGRAMMING THE AUTO DIAL KEYS

Depending on your iPhone model, there may be programmable guest service keys located above the dialpad. These keys can be used for one-touch access to commonly dialed num- bers or services. To program these auto-dial keys, the telephone must be connected to an active telephone line.

Programming of these keys is protected from unauthorized tampering, and employs the use of “hidden” programming keys located underneath the faceplate. With the clear plastic overlay and faceplate removed from the phone, locate the STORE key as noted in the phone diagram. This recessed key is located above number ‘3’ in the dialpad.

To program an auto-dial, or guest service, key:

1)Lift the handset from the cradle, or press the SPEAKERPHONE key.

2)Press the recessed STORE key and release it.

3)Enter the number or extension to be programmed.

4)Press the auto-dial key where the number is to be stored.

5)Repeat this procedure as necessary for additional auto dial keys.

6)Place the handset back in the cradle, or press the SPEAKERPHONE key to disconnect.

‘PAUSE’ KEY		‘STORE’ KEY
1	2	3
4	5	6
7	8	9
	0	#

PAUSE KEY

The PAUSE key can be used to provide a timed pause between dialed digits within a stored auto dial number. The timing of the pause is programmable, with the factory default set to one (1) second. To change the pause timing:

1)Lift the handset or press the SPEAKERPHONE key (speakerphone-equipped models.)

2)Press the STORE key (see diagram on inside front cover for key location.)

3)Press the PAUSE key (see diagram for key location.)