Oricom W1 manual Basic Operations, During standby, Answering an incoming external call

charge. This is normal. A handset reaching a very low battery voltage level will go into sleep mode, displaying LOW BATT on the screen.

It is good practice to replace the handset on the base unit to charge when it is not in use to ensure the handset is always fully charged.

RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. Refer to the original type supplied with this phone. Ni-MH rechargeable batteries must be disposed of in accordance with applicable waste disposal regulations.

BASIC OPERATIONS

During standby

ORICOM 1

When the phone is in standby, the LCD displays the handset label. The handset number related to the connected base will also be displayed right justified. The battery icon reflects the current battery level and the signal icon indicates the handset is linked to the base.

Answering an incoming external call

JOHN

When there is an incoming call, the phone rings and flashes. If a CID record is received, the caller information is displayed.

turns on if the phone number contains more than 12 digits. In this case, only the last 12 digits are displayed.

If you press when the phone is ringing, the handset ringer will be turned off for this incoming call.

1.Press to answer the call. turns on.

2.Call timer is displayed 10 seconds after the call is connected

3.Press or place the handset on the base cradle to disconnect.

9