Getting Started, Setup 2422 Accessory Handset

Getting Started	Setup

Registration And Operation Of The 2422 Accessory Handset

Your Sprint GIGAPHONE system can operate up to 4 Handsets. The accessory Handset consists of the following:

Handset Belt Clip Battery Pack Charger Unit

	Setup		Of	The	2422
	Accessory Handset
	1.	Plug the AC power adapter into an
1	2.	electrical outlet.
		Remove the Handset battery cover

		by pressing on the indent and sliding
	3.	downward.
		Place the new battery pack in the
3		Handset, with the metal contacts
		aligned with the charge contacts in
	4.	the battery compartment.
		Replace the battery cover by sliding
	5.	it upward.
		Place the Handset in the Charge
	5	Cradle, and allow it to charge for 12
		hours.	After	the initial	charge, a
		maintenance		charge of	8 hours

should be sufficient.

Installation of Battery Pack in Handset

1		Follow the steps below:
		1.	Remove the battery cover by pressing

	3	2.	on the indent and sliding downward.
			Place the new battery pack in the

handset with the metal contacts aligned with the charge contacts in the battery compartment.

3. Replace the battery cover by sliding it upwards.

4. If the new battery pack is not already charged, place the handset in the base unit, or a remote charging stand, and allow it to charge for 12 hours. After initial charge, a maintenance charge of 8 hours should be sufficient.

The original Handset that is shipped with your Sprint GIGAPHONE system will be automatically registered to the Base. This Handset is HANDSET 1.

As you register additional Handsets to the system, they will be assigned extension numbers in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4.

Whenever a Handset battery pack is installed, the Handset will automatically begin SEARCHING FOR BASE (if previously registered), or it will prompt you to ENTER BASE ID to register the new Handset.