Oricom ECO5100 manual Pause feature when using on a Pabx, Recall function when connected to a Pabx

BASIC OPERATION

3. Repeat steps 1-2 to swap between the two callers.

Recall settings are: Australia (100ms, SHORT) and New Zealand (600ms, LONG).

If this feature does not work correctly, check the country option. To change the Recall settings, press and hold /P key on the cordless handset to switch between “LONG” and “SHORT” on the display.

Recall function when connected to a PABX

If you have connected your telephone to a PABX, you can use all the facilities such as

call transfer, automatic recall, etc. The key provides access to these facilities.

Pause feature when using on a PABX

Note: The pause function described in this section is only necessary when the eco5100 is used on older PABX’s.

With some PABX's, there is a short pause between the code for the outside line (usually 0 or 9) and obtaining dial tone. A pause needs to be entered manually and stored in the phone book so that the numbers are not dialled too quickly.

When storing numbers in memory, you can include the outside line access digit (e.g. ‘9’ or ‘0’) with each phone number. LNR function or memory dial may not work when using your telephone on a PABX. Insert a pause between the OUTSIDE LINE DIGIT & the

TELEPHONE NUMBER.

1. Press the numeric keys to enter the OUTSIDE LINE DIGIT.

2. Press /P key to insert a pause.

3. Press the numeric keys to enter the TELEPHONE NUMBER.

12