Oricom PMR888 manual

You can specify a different code for each channel.

1.To set a channel and code combination, press

once and then press or to select the channel.

2.Press again and then press or to select a code.

3.The radio does not support interference

eliminator codes on channels 5 or 35. On these channels press . The radio will skip the code settings.

4.Press “PTT” to exit the menu and to save the channel and code combination.

To set another channel and code combination, repeat these steps.

Scan advance

If scan stops on a channel that you don’t want

to listen to, briefly press or to resume scanning for the next active channel.

Nuisance delete

If scan continuously stops on an undesired

channel, press and hold or for at least 3 seconds, then release. This will temporarily remove the undesired channel from the scan list.

To restore the channel to the scan list, turn the radio off and then on. You cannot remove your home channel from the scan list (your home channel is the channel your radio was set to when you activated scan).

Monitor mode

This feature allows you to listen for weak signals on the current channel.

1.Pressing and holding allows you to monitor your channel for activity.

2.Adjust volume up or down.

Keypad lock

The keypad lock disables all the buttons. But allows

you to use the button to monitor the channel. Press and hold for 3 seconds to lock or unlock the keypad. When the radio is locked will appear in the display.

Sending a call tone

A call tone alerts others in your group that you want to talk. Your radio has 10 call tones to choose from.

7.