Pre-Dailling, Last Number Redial

PRE-DAILLING

Pre-dial allows you to enter a telephone number and verify it on the screen before you place the call. The screen displays the last 12 digits dialled but you can enter up to 2 digits.

∙In standby mode enter the phone number you wish to dial.

∙To enter a pause, press the button and a dash “-“will appear in the display.

∙If you make a mistake, press DEL to erase one digit at a time. Or you can press and hold the DEL button to clear the entire number and return the phone to standby.

∙Press to dial out the number.

∙To end the call, press the button again, or replace the handset back in the base.

Note:If you have connected this phone to an office phone system (PBX) you may need to enter a pause for a few seconds between dialling the line access code and the actual phone number.

To pause, press the button and a dash “ - “will appear in the display.

LAST NUMBER REDIAL

You can review and call back the last 3 numbers you have dialled as your cordless stores them in the redial memory.

∙In the standby mode press the button to scroll through the last 3 numbers you dialled.

∙Select the number you want to redial and press , to dial the number.

CALL DURATION TIIMER

When you make or answer a call the display shows the call duration in time minutes and seconds.

ADJUSTING THE EARPIECE VOLUME

During a call, to adjust the volume in the handset’s earpiece or speakerphone press

the volume button repeatedly .

The display shows the current volume level: the more “0’s” the highest the volume (“0” to “00000”).

TO PAGE THE HANDSET

This function is useful if you can’t find your handset.

∙On the base unit press and release the button. The handset rings with a special tone.

∙To stop the handset ringing, on the handset press any button or numbered key.

-8 -